![]() ![]() ![]() You can see the main window in the above screenshot. PonyProg 3.0 main window after reading an I2C EEPROM It would be nice if a future version would support the modern USB based programmers (like the CH341A MiniProgrammer) which lack a good software. ![]() ![]() With serial port, it communicates by bit-banging various protocols to the signaling lines contained in the RS232 interface (RTS, CTR and DTR). The schematic of the interface can be found at the author's page ( SI-Prog by Claudio Lanconelli).Ĭurrently, PonyProg only support SI-Prog or other serial based programmers and some parallel port programmers. If you still have an older computer with a motherboard serial port, you may take into consideration building the serial adapter used by PonyProg, because it is easy to build and probably the cheapest programmer possible. And computers with a real serial port are becoming very rare. It doesn't work with USB to serial converters. However, this approach has a big downside nowadays. This adapter consist of only some resistors and some voltage limiting zener diodes. PonyProg is a software application that can read, write and program various memory chips and microcontrollers using the simplest possible interface: a serial port adapter. It comes with a good-looking Qt based interface. A new version of the serial device programmer PonyProg has been released. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |